To find water content, weigh the sample before and after drying, then use a mass‑ratio formula to convert the loss into a percentage.
Wet‑basis versus dry‑basis
Wet‑basis moisture content expresses water mass as a fraction of the total sample mass, including solids and liquids:
Mw = (mw ÷ mt) × 100
Dry‑basis moisture content uses only the dry solid mass as the denominator:
Md = (mw ÷ ms) × 100
Choose the basis that matches the industry standard—grains use wet‑basis, soils and chemicals use dry‑basis.
Gravimetric method
The most reliable approach is to dry the sample in a calibrated oven. Typical steps:
- Weigh the empty container with an analytical balance.
- Place the sample, record the initial wet mass.
- Dry at 105 °C (or lower for heat‑sensitive items) until weight stabilises.
- Cool in a desiccator to avoid moisture uptake.
- Weigh again to get the dry mass.
Water mass equals the difference between wet and dry masses. Apply the chosen formula to get the moisture percentage.
Volumetric water content in porous media
Field studies often need the volume of water per unit bulk volume:
θ = Vw ÷ Vt
Because Vw is hard to measure directly, convert from dry‑basis mass using bulk density (ρb) and water density (ρw≈1 g cm⁻³):
θ = Md × (ρb ÷ ρw)
Measure a core of known volume, dry it, then compute ρb by dividing dry mass by volume.
Advanced non‑destructive techniques
When speed matters, dielectric sensors such as time‑domain reflectometry (TDR) or frequency‑domain capacitance sensors estimate moisture by measuring pulse speed or permittivity. Calibration curves translate the electrical signal into volumetric water content.
For liquids or trace moisture, Karl Fischer titration offers ppm‑level precision by chemically reacting water with iodine and sulfur dioxide in a base solvent.
Common pitfalls and solutions
- Volatile organics can evaporate with water, inflating results—use vacuum or freeze drying to minimise loss.
- Incomplete drying leaves bound water, ensure a constant weight is reached before recording the dry mass.
- Ambient humidity can re‑absorb moisture, cool samples in a desiccator before weighing.